Raco Guard-It User Manual download pdf (Page 5)

Programming Your Guard-It

Autodialer

4-4 Guard-It

Owner's Manual

PHONE

NUMBERS

Example:

To configure input channel 3 to alarm on Open Circuit, from the top menu

press:

1 3 1

Refer to Appendix A for additional information on programming for analog

signal inputs.

4.1.2 Phone Number Programming

You must program at least one phone number for your Guard-It

autodialer

to dial when it has an alarm to report.

! Note:

Until you do so, any alarms which are detected will be automatically

acknowledged without any alarm calls being placed.

To program phone numbers, you must first select which of 8 available phone

numbers (first, second, etc.) you want to program. The voice menu will ask you

for this number, which will be a number from 1 to 8. Then it will recite the

presently programmed phone number for that selection, if any. Then it will

allow you to accept the current entry by pressing pound (#), or else enter a new

phone number for that selection.

Be sure to include any necessary prefixes or area codes, just as you would dial it

on an ordinary telephone.

As you enter each digit, be sure to listen for the voice to repeat back that digit,

before you enter the next digit.

Example:

To program the third phone number to be 1 (510) 658-6713, from the top

menu you would press [2] for phone number programming, then [3] to select

the third phone number, then:

1 5 1 0 6 5 8 6 7 1 3 #

Listen carefully as the completed entry is repeated back to you, to be sure it

was entered and accepted correctly.

To delete a phone number, program it to be 00.

For example, to clear out the fourth phone number, from the top menu you

would press [2] for phone number programming, then [4] to select the fourth

phone number, then:

0 0 #.

1 2 3 4 5 6

No comments

Raco Guard-It User Manual Page 5